Script doesn't compile in MHS 4.0.0.14 - Preprocessor failed

[daenerys]

Hi Spiro,
first of all thank you for the wonderful work you are doing with MHS and sharing these all goodies what all of us. I am a real fun of you, I have to admit. I hope you are doing well....
Now to the issue.
I have an old script (it still compiles and works well with the old MHS demo 21) and I tried to compile it with the new 4.0.0.14 (so basically I want to "upgrade" from demo 21 to 4.0.0.14) but the compiler is giving always the following:
"ERROR: Preprocessor failed. Compilation is still possible if no macros or includes are used."
I am not using any macros or whatever what would be relevant for the preprocessor (actually in the demo 21 there was no preprocessor available at all)...
I can send you directly the mentioned script in order that you can try to compile it if necesary. Just tell me your address...
Thanks again,
daenerys

[L. Spiro]

You should send the script. My e-mail is on the site.

Demo 21 was years ago.


L. Spiro

[daenerys]

OK.
I have sent you the script right now.
Thanks,
danny

[daenerys]

Nevermind, I found the error
Some escape characters (0x7, 0x5 etc) in my script obviously caused the preprocessor to go berserk. After deleting them, the script compiles 1A.

Thanks anyway,
danny

[L. Spiro]

That’s the solution I would have found 6 hours from now when I would have tested it.

I have been quite busy and that would have been my first chance to run your files.


L. Spiro