Suggestion : new SubSearch

[minorutono]

Ok, Im getting really annoyed. As I search for value [0], I get a bunch of returns, right? However, about half of them flicker between 0 and other numbers. When I SubSearch Same as Before, I only eliminate about 1/20th of the values that are flickering between 0 and other numbers.

Could it be possible to make a SubSearch "Hasn't Changed", where it'd look to see if the values in the addys on the search return Haven't changed at all since the last search?

Like if it was at 0, then went to 1234, then back to 0 when you SubSearched, it'd know that the value went to 1234 and eliminate it, even though right now it is returning 0.


Sorry if its noob or impossible, just throwing my ideas out.

[L. Spiro]

It is impossible to make such a search.

Look at the addresses of the values that are flickering. They are all very low. That is because they are on the stack. Change your search range to eliminate them.


L. Spiro

[minorutono]

Ok, cool.

Thanks for responding.

Too bad its impossible to make that search.