Page 1 of 1
Bug with MHS 4.0.0.14
Posted:
Sat Feb 16, 2008 3:52 pm
by Fenix
hi
I think there is a bug with the new mhs.
if i open disassembler, mhs bug and i must to close the program.
Edit:
If i want attach maple story to mhs, i must to run this program on admin but disassembler doesn't work.
If i don't run admin, can't attach maple story.
I use vista basic.
Posted:
Sun Feb 17, 2008 8:17 pm
by L. Spiro
You have to run as administrator.
L. Spiro
Posted:
Sun Feb 17, 2008 9:24 pm
by Fenix
I can't open disassembler (disassembler doesn't work with all processus).
I think it's vista.
Posted:
Sun Feb 17, 2008 9:52 pm
by aldis
Fenix wrote:I can't open disassembler (disassembler doesn't work with all processus).
I think it's vista.
yep.. he dont tested yet the new version on vista
Posted:
Mon Feb 18, 2008 10:05 pm
by BlackDove
Yes, I can confirm this bug in Vista 32-bit. It's not the program - I can't even open up the disassembler for calc.exe.
http://img255.imageshack.us/img255/6532/errormx1.jpg
(Access violation)
Hopefully you aren't too busy in SF!
And thanks for this version - I see you implemented a couple of my suggestions.
Posted:
Tue Feb 19, 2008 8:46 am
by Areks
I THINK I'm attached to maple, because I searched my hp value and got it down to 1 thing, every sub search for my new HP value had the same adress.
Nevermind, went to hex editor, there was MHS's memory.
How would I go about actually changing a value like the damage I do or take?
Posted:
Fri Feb 22, 2008 10:55 am
by BlackDove
...still wondering if the disassembler will be addressed soon.
Thanks.
Posted:
Fri Feb 22, 2008 2:20 pm
by L. Spiro
San Francisco/Tokyo will end next week and I can look then.
L. Spiro